Доброго времени суток, форумчане-хондаводы. Есть проблема. Несколько недель назад загорелись датчики OBS, VSA. и не отключаются. Компьютер показал вот эту проблему:21-11 right-front magnetic encoder malfunction.
Сталкивались ли с этим? Какие есть способы решения? Интернет поиск ничего внятного не дал. На форумах не нашла темы.
Заранее спасибо.:)

DTC Troubleshooting: 21-11, 22-11, 23-11, 24-11

DTC 21-11: Right-front Magnetic Encoder Malfunction (Pulse Missing)


DTC 23-11: Right-rear Magnetic Encoder Malfunction (Pulse Missing)




1. Turn the ignition switch ON (II).

2. Clear the DTC with the HDS.

3. Test-drive the vehicle. Drive the vehicle at 20 km/h (13 mph) or more, and go a distance of 100 m (328 ft) or more.

4. Check for DTCs with the HDS.
Is DTC 21-11, 22-11, 23-11, and/or 24-11 indicated?


YES - Go to 5.


NO - Intermittent failure, the system is OK at this time. Check for loose terminals between the wheel sensor 2P connector and the VSA modulator-control unit 37P connector. Refer to intermittent failures troubleshooting.n



5. Turn the ignition switch OFF.

6. Inspect the appropriate magnetic encoder for debris or cracks.
DTC Appropriate Magnetic Encoder Note
21-11 Right-front Remove the outer driveshaft joint from the appropriate wheel hub.
22-11 Left-front
23-11 Right-rear Remove the hub bearing unit.
24-11 Left-rear


Is the magnetic encoder surface OK?


YES - Replace the wheel bearing or the hub bearing unit:n

Front: Replace the front wheel bearing.
Rear: Replace the rear hub bearing unit.

NO - Clean off dust or dirt from the appropriate magnetic encoder surface on the wheel bearing or the hub bearing unit then go to 1 and recheck.n




Короче, смотри передний правый датчик абс

thanx